SavvyCAN with ESP32 Running ESP32RET

Directly connect SavvyCAN to ESP32 with a CAN shield over Wi-Fi Access Point.
10 PCBs for $5 USD at https://www.pcbway.com
Get the ESP32 CAN Shield - https://store.mrdiy.ca/p/esp32-can-bus-shield

I did not create SavvyCAN or ESP32RET; all credit goes to Collin Kidder - https://github.com/collin80

Products I used
=============
■ ESP32 (Amazon) - https://amzn.to/3QMFvXn
■ ESP32 (AliExpress) - https://s.click.aliexpress.com/e/_DdzxYGV
■ CAN Shield - https://store.mrdiy.ca/p/esp32-can-bus-shield

Links
=====
■ Online Flasher - https://mrdiyca.gitlab.io/mrdiy-esp-online-flasher
■ ESP32RET - https://github.com/collin80/ESP32RET
■ SavvyCAN - https://www.savvycan.com

Join this channel to get access to perks:
https://www.youtube.com/channel/UCtfYdcn8F8wfRA2BXp2FPtg/join

Follow on X: https://x.com/MrDIYca

Music by Maksym Dudchyk.The links above usually are affiliate links that support the channel (no additional cost for you).

In this video, we'll guide you through setting up an ESP32 with a CAN Shield to directly access a CAN bus using SavvyCAN. If you've followed my previous CAN project videos, you know I've covered this topic before, but this time we'll bypass the framework and load the ESP32R firmware directly. We'll configure the CAN Shield, modify firmware settings, and demonstrate how to establish a two-way communication with SavvyCAN. Plus, I'll show you how to troubleshoot and utilize extra features like indicator LEDs.

00:00 Intro
00:13 My framework
00:38 Alternative
01:09 ESP32RET
01:39 HowTo Flash
01:58 HowTo Setup
02:31 Sponsor
03:01 HowTo config SavvyCAN
03:48 Outro