How to make an IR Sniper for the Flipper Zero.

Published at : 23 Dec 2025

This is my version of an IR Blaster for the Flipper Zero.

Short of an IR Sniper using a camera with IR filter removed to show how bright it is.
https://youtube.com/shorts/dOsd7repQVI?si=6bCbsSazlYW8fAtv

My other DIY videos for the Flipper Zero:

CC1101 DIY
https://youtu.be/WM2bWjn5jOY?si=hsRa-lDHlmV_HlQi

NRF24 DIY
https://youtu.be/64U4pRANOSc?si=T3ft_TpBBARJL5D

ESP32-CAM DIY
https://youtu.be/AKlCGNhASFU?si=NL93SYoL1yA5lV4N

3D parts STL:
https://www.printables.com/model/633940-rj019-ir-sniper-flipper-zero

Textured Sheet I used to get the Carbon Fibre pattern on the prints.
https://s.click.aliexpress.com/e/_mO5lZjo

PARTS I ORDER BELOW:

5W 940nm IR LED Torch (do NOT get VCSEL)
https://s.click.aliexpress.com/e/_mqPFWvW

Optocoupler 4N33
https://s.click.aliexpress.com/e/_mO77VTQ

24 AWG Silicone Wire
https://s.click.aliexpress.com/e/_mPV4nN4

Prototype Board
https://s.click.aliexpress.com/e/_mNTKO5s

PCB Board Pins 11.2-11.5mm
https://s.click.aliexpress.com/e/_mLFKNAA

Helping Hand
https://omnifixo.com/

Soldering Iron
https://s.click.aliexpress.com/e/_m0DIxVk

If you would like to support the channel, you can do so by the below. All funds will go towards purchasing more parts to make more content for the community.

https://www.buymeacoffee.com/rayj