Generac XG10000E Carburetor and Governor
Published at : 23 Dec 2025
Episode 1 of Jay Fixes Stuff - We take on a Generac XG10000E, take it apart, clean the carburetor, throw some tools, discuss governor and engine speed challenges and load test it.
A fun small engine repair project on this Generac generator.
----
0:00 - Introduction
1:37 - Handle Button Workaround
2:32 - Welcome
3:34 - Tank, Rollover Valve and side rail removal
9:39 - Airbox Winter Summer Modes
10:00 - Airbox & Engine Speed Droop
12:00 - Airbox Removal & Discussion
18:50 - Linkage Discussion
20:44 - Governor Rod & Anti-Surge Spring Orientation
22:40 - Carburetor Removal
34:25 - Governor Adjustment
35:20 - Governor Calibration
36:44 - Carburetor Cleaning
1:10:40 - Carburetor Installation
1:17:00 - Governor Rod
1:17:50 - Governor Spring and Bracket
1:20:04 - Airbox Installation
1:37:08 - Finishing Reassembly
1:43:09 - Load Test
1:46:13 - Conclusion
Note: In this video I commented that it was odd that the rollover valve allowed air in to the tank freely but did not allow air out. As it turns out, the valve was defective and cleaning it restored airflow in and out.
#smallengine #smallenginerepair #generator #canwefixit