FPV Drone Assembly Guide 2025 - Long Range Budget Build | Part 1

I’m going to show you how to assemble a budget 7-inch FPV drone.
In this video, we’ll go over all the parts and walk through the step-by-step assembly process.
In the next video, we’ll upload the firmware and configure the drone.

This build features one of the best VTX units for long-range flights.
For the other parts, we’ll be using affordable copies from China. If you'll buy electronics with discouns (usually the first dates of month) the entire build will cost less than 150$!

Components i've used:

Frame - Mark 4 https://s.click.aliexpress.com/e/_okxJ6FX
Stack - SoloGood f405 https://s.click.aliexpress.com/e/_oFM247B
Motors - Noname 2807 1300kv https://s.click.aliexpress.com/e/_onqHoG1
VTX - Rush Tank Max Solo 2.5w https://s.click.aliexpress.com/e/_oCBhsEz
Camera - Caddex Ratel 2 https://s.click.aliexpress.com/e/_oFf3g1m
Antenna - Rush Cherry 160mm RHCP https://s.click.aliexpress.com/e/_opI3nNX
RX - Bayck ELRS 915Mhz: https://s.click.aliexpress.com/e/_olEjPR7
Props - HQProps 7040 https://s.click.aliexpress.com/e/_oD23nwm
Battery - 6s2p LiOn

Tools:
SmokeStopper - https://s.click.aliexpress.com/e/_oFw62eV
Soldering Iron - https://s.click.aliexpress.com/e/_ontjJnx
Screw Driver - https://s.click.aliexpress.com/e/_oDmqZgN
Cutters - https://s.click.aliexpress.com/e/_oEsZDtX
Multimeter - https://s.click.aliexpress.com/e/_oDhDxVr

00:00 Introduction
00:37 Components list
04:05 Frame assembly
05:28 ESC Soldering
07:48 Wiring Motors
09:27 VTX connecting
12:10 Receiver
13:31 Camera
14:21 Assembly check

#FpvDrone #CustomDrone #FpvDroneBeginner #FpvDroneBuild #CustomDroneBuild #7InchDrone #FpvSetup2025 #BudgetFpvDroneBuild2025 #BudgetFpv #BudgetFpvDrone #BudgetFpvDroneBuild #BudgetFpvDroneSetup #AssemblyGuide #SolderingDroneComponents #SolderingDroneMotors #SolderingDroneEsc #DroneSolderingIron #SologoodFpv #RushTankSoloVtx #RushTankSolo #RushTankVtx #RushTankSoloMax