DIY CO2 Laser Cutter Build. Open Source GRBL ESP32/Arduino/DLC32

Open Source CO2 Laser Cutter Build.

Timestamps
00:26 Intro
01:49 Cabinet
04:02 Gantry
11:31 Outer Frame
12:13 Electronics Panels
13:46 Ducting
14:23 Gantry Panels
15:54 Lid Install
16:23 Tube Install
16:46 Chiller Install
17:48 Wiring
18:33 Electronics Overview
19:30 Laser Head Install
19:56 Outside Frame Panels
20:22 First Steps

Specs:

Working Area: 600x400mm

Laser: 90 Watt SPT Laser Tube- C90
https://www.sptlaser.net/co2-laser-tube/c-series

Power Supply: MYJG-100W

Extraction Fan: AC Infinity Cloudline S6 EC

Water Chiller: S&A CW-5200TH

Controller: Makerbase DLC32
https://github.com/makerbase-mks/MKS-DLC32

Firmware: GRBL ESP32
https://github.com/bdring/Grbl_Esp32

Software: Lightburn
https://lightburnsoftware.com/

Project Repo:
https://github.com/kpatel122/Sparks-Laser-Cutter

(All links are non-affiliate)

DISCLAIMER: CO2 lasers and their electronics are dangerous. This information is provided for educational purposes only, use at your own risk- be safe.