A subscriber sent this Beacon generator to me I think as a challenge. It is in bad condition. After sorting out the engine issues in part 1, I could see that the generator was not making power. I found damage on the power control board (PCB). The stator and rotor tested well so I sent the PCB out for repair. Upon installing the repaired board the generator made power, but the silicon controlled rectifier (SCR) immediately blew out and the engine went under a heavy load. The board failed in the same way as I found it before sending it for repair. I tested the insulation at 1000 volts and did not find a fault. I am going try my luck one more time and get the PCB repaired again.
Beacon Part 1:
https://youtu.be/13sBj8a-xJwPCB Board Repair 1:
https://youtu.be/MH4Leo333cgPCB Board Repair 2:
https://youtu.be/zWnRzomlQKgBassguitarist1985 (aka Gary):
https://www.youtube.com/@Bassguitarist1985Generator Model: 01277-0
Engine Model: GN-410 EHF-04108-1
Power Control Board (PCB) Part Number: 84132GS
System Control Board (SCB) Part Number: 83970GS
I use Harbor Freight Super Heavy Duty Degreaser in my ultrasonic cleaner.
Visit My Amazon Store:
https://www.amazon.com/shop/jamescondon3 Jaw Puller:
https://amzn.to/3AEXyagAnti Lash Spring:
https://amzn.to/3VpmdaGCaliper:
https://amzn.to/3V3aXkMDead Blow Hammer:
https://amzn.to/3B2K3BJLab Power Supply:
https://amzn.to/3GESJl4Oil Filter:
https://amzn.to/3GFMJskPB Blaster:
https://amzn.to/3i0UgYpScissor Jack:
https://amzn.to/3tW4w70Squeeze Bottle:
https://amzn.to/3iaiwHBTest Light:
https://amzn.to/3AEy650Tygon Fuel Line:
https://amzn.to/3XprQaXIf you want to donate to the channel, you can use the YouTube "Super Thanks" feature.
#GeneratorRepair #SmallEngineRepair #SmallEngine #DIY #Fixed #Troubleshooting #HowTo #Generac
01277, 01277-0, 5500EXL, 5500XL, 7550EXL, 7550XL, 83970GS, 84132GS, Anti Lash Spring, Anti Surge Spring, Bad Excitation Winding, Bad Stator, Beacon Group, Beacon, EHF-04108-1, Engine Goes Under Load, Fire, Fixed, Flying Short, GN-410, Generac EXL, Generac XL, Generac, Generator, Hertz, How To, How-To, No Output, No Power, No Voltage, Oil Pressure Test, PCB, Power Control Board, Rotor Removal, Rotor Test, SCB, SCR, Small Engine, Smoke, Stator Removal, System Control Board, Troubleshooting, Voltage Regulator