Atlas Craftsman Lathe Reassembly, Testing, and First Chips

In this video I complete the restoration on my 12 inch Atlas Craftsman metal lathe. I reassemble the lathe on its new bench, test all the functions such as back gear, power feed, cross feed, and quick change gear box. Finally, I make some test cuts in a piece of scrap brass.

Supplies:
Rust Remover: https://amzn.to/3ZI45M9
SEA 20 Machine Oil: https://amzn.to/3ZrjXCx
SEA 20 Non Detergent Oil: https://amzn.to/3ZNWOty
Link Belts: https://amzn.to/3kQGGIY
Shop Towels: https://amzn.to/3yjbRQg
WD-40: https://amzn.to/3ITSfHj
Degreaser: https://amzn.to/3IWdlVI
Blue Tape 1": https://amzn.to/3L1SRxc
Blue Tape 2": https://amzn.to/3yjA2OE
Primer: https://amzn.to/3kTDqMZ
Paint: https://amzn.to/3kVsnmo
Clear Coat: https://amzn.to/3F5puX0

Tools:
Chuck Wrench: https://amzn.to/3IZN0Gl
Oil Can: https://amzn.to/3YqV4pg
15L Ultrasonic Cleaner: https://amzn.to/3ITVte1
Hearing protection: https://amzn.to/3IWmgGv
Safety Glasses :https://amzn.to/3ZDnLQK
Mask/Respirator: https://amzn.to/41MvrCd
Wrenches: https://amzn.to/3F45B2I
Ratchets: https://amzn.to/3mtzseu
Pin Spanner Wrench: https://amzn.to/3IWiYmQ

Camera Equipment:
Canon SL2 - https://amzn.to/2GPW1ms
Tripod - https://amzn.to/2XWVhSd
GoPro: https://amzn.to/3tKVjiB